Quality kitchen and appliances can be purchased as a complete kit consisting of the elements of standard sizes. Built and installed his own. However, this furniture is suitable, as a rule, only for more or less spacious kitchens. Of the many ready-made suites of DIY is better to choose the one with the assembly which is able to show their creativity and practical skills. Kits typically include cabinets, for example, a width of 30, 40, 50 and 60 cm, wall cabinets, floor cabinets, pencil cases and boxes for electrical appliances, doors to the cabinet in various designs, various accessories, kitchen worktops of varying length, which with the help of special profile can be connected at an angle to the panel (with the same as that of the working surface of the plates) for the cladding of the wall under the wall cabinets, aluminum structure as a finite element shell (it can be secured with hooks and wire basket for bottles, paper roll holder for or foil). From the most essential electrical kitchen fridge and dishwasher. Collected furniture set in place. With a flat rack and expose them to the level horizontally on the same level (except oil in a frying pan will flow in one direction). The hole in the slab kitchen table cut electrofret, first drilled in the corners of the future opening holes saw blade. The height adjustable legs set far pedestals. They can be equipped and cabinets, the original design of which such feet are not provided. The legs are then covered with a cap (the color of the doors thumbs) or basement drawers. Cutting edges promazyvayut silicone sealant. Plate should be careful not to damage the side jumper. Plates kitchen desks lie along the length and (for T-and U-shaped configuration) connect with each other using a special profile. On plates openings for embedded equipments The hole in the slab kitchen table electrofret cut, pre-drilled in the corners of the future opening holes saw blade. Strengthen wall cabinets start from the corner. Fittings for hanging (you can buy separately) will then simply set the cabinet, without removing it from the hooks. Before installing kitchen furniture and equipment you need to complete the installation of pipes and electrical wiring, not forgetting also a sufficient number of sockets to connect small electrical appliances and fixtures. ceramic tiles on the wall between the kitchen desk and wall cabinets can be replaced with panels that picked the color of the kitchen desktop. Studs are fixed on the dowels under the table top and for the wall cabinets. Panels cut out to the width of the open section of the wall. Hinged panels are connected to each other on the water-resistant glue to the tongue and groove. Seal the seams with silicone sealant.